Jalecom's latest activity
-
JJalecom replied to the thread Does anyone have any experience with the Augentix HC1703 chip?.Hi dhigginb, glad to know it works for you too! If you have a chance to browse the files of your camera check the start.sh and tell me...
-
JJalecom replied to the thread Does anyone have any experience with the Augentix HC1703 chip?.Not so much: if you have no pad (bigger than the tiny pin) and you can't find any different place to solder a single tiny wire, or to...
-
JJalecom replied to the thread Does anyone have any experience with the Augentix HC1703 chip?.Wow, nice! Uploaded on the repository. Thank you.
-
JJalecom replied to the thread Does anyone have any experience with the Augentix HC1703 chip?.Hi Gikgamer, Unfortunately the two holes you marked are connected eachother, I suppose the signal will go on the other side of the PCB...
-
-
JJalecom replied to the thread Does anyone have any experience with the Augentix HC1703 chip?.Never used a raspberry, however if it has a high impedence 3.3V serial input, you can use it too. Configure the terminal settings to...
-
JJalecom replied to the thread Does anyone have any experience with the Augentix HC1703 chip?.No, desolder the Soc is not an option. I suggest to check the pins next the "H" of the HC1703 SoC: as in my camera the serial in/out...
-
JJalecom replied to the thread Does anyone have any experience with the Augentix HC1703 chip?.It seems no serial pad are visible near your Augentix SoC however you can look for a 57'600bps signal on the SoC pins: the processor...
-
-
JJalecom replied to the thread Does anyone have any experience with the Augentix HC1703 chip?.On my AJ HC1703L it is possible to load from SD a SSH Server and start it with few commands on the debug_cmd.sh, then any command is...
-
JJalecom replied to the thread Does anyone have any experience with the Augentix HC1703 chip?.No, If you find the two serial pin (pay attention 3,3V, you need an adapter) you can stop the boot process in several different ways...
-
JJalecom replied to the thread Does anyone have any experience with the Augentix HC1703 chip?.On the Augentix HC1703L check GitHub - Jalecom/AJ_HC1703L_Teardown: PTZ IPCam based on SOC Augentix HC1703L teardown On the Goke GK7102...
-
JJalecom replied to the thread Does anyone have any experience with the Augentix HC1703 chip?.Hi GYKGAMER, I played a little bit with a PTZ camera based on the Augentix HC1703 and I can confirm I gained the root on the serial too...
