Recent content by Heavyopp

what camera?

If the time and date are correct in the camera then it should run. Maybe try a power cycle on the camera just to reboot. I program mine with day, general, night. General is for the transitioning light at dusk and dawn. My time chart looks no different than yours other than the 3rd color. No...

Is camera showing the proper time? Do you have the right time zone set? Daylight savings? Do you have the night setting set up? What camera are we talking about?

Ever get one where the gator eats the bird?

What bird is that in the #3 photo? Don’t have anything with that kind of coloring in NJ.

Early 70's we open trenched everything - Owned a few ditch witch J20 trenchers - Still have 1 -1970 vintage 1st pullers we had where probably late 70's early 80's - ditch witch V252 - Still have and run 1 - my current puller is late 80's early 90's vintage ditch witch 350 sx -- engine rebuilt...

Look on the upper right side of the screen, near the gutter. Most likely aluminum trim coil. Starts out nice, looks like it was blasted by a shotgun by the end. Imagine all that small debris flying around, what it would do to a human.

The vibratory plow "puller" is basically a knife blade with a sling attached for holding pipe or wire. Lower blade into ground, vibrate the blade, and drive slow. Pipe gets dragged underground behind the blade. Damage to ground is really dependent on soil conditions and pulling depth. Roots are...

https://empiretech01.com/collections/network-video-recorder Says he ships all over the world -- This is Andy's website, forum sponsor and a pleasure to deal with.

This one works just fine for me, I don’t have 8 cams running off it yet but but the 4 I do have running work just fine with the BI machine plugged into the uplink port. You also get some sfp. https://www.amazon.com/gp/product/B09DRWY7X2/ref=ppx_yo_dt_b_asin_title_o09_s00?ie=UTF8&th=1

Use what you have...

Thanks.

Is there a thread where you talk about the newer cams and not needing the extra IR? Link? I'll be setting up LPR soon and just want to read what some of you guys are doing.

I also have the illuminar unit talked about here. That one says DC12 volt or AC 24 volt input. I have a butt load of 24 volt Ac transformers. Has anyone tried the tendelux unit on 24 volt ac? Will it just not work or will it brick the D110? @Parley and @StevenFromTexas What voltage are you...

I just re-read the product description - Input voltage 12 to 24 volts DC. I purchased 2 of the D110 in the past 2 weeks, noticed both have 24 volt wall warts although the directions say confirm 12 volt power supply. Was hoping they were not overdriving the diodes to gain some short term...