Recent content by Halobiont

In case anyone comes across this thread the above IVMS solution did not work. I upgraded the firmware for each camera which solved this problem. Actually my camera installer called someone who remoted into his laptop and upgraded the firmware. I had another camera that was not broadcasing the...

Hi, I have ATT fixed wireless and port forwarding is not allowed. I use Guarding Vision on IOS for viewing cameras while away. I'm trying to be able to view the cameras on a PC. IVMS-4200 does not seem to have the ability to view Guarding Vision, only Hik-Connect. I'm not sure if I can set...

I found th4e answer for this problem. If you're using IVMS software make sure you set up an "operator" or non-administrator user account. If you use an administrator account this problem will occur. Good luck.

Ok Thank you. I'll try this. There are only a few cameras that do this so you may be right about some damage. However I do have different models. I'm not an expert so resetting to OEM state probably means I have to reset the IP addresses and I need to make sure I'm ready to do that...

Hi, I just about have the configurations needed between Basic and Smart Events, then the power goes out and resets everything. I login into the NVR and change the settings and with a power outage it reverts. I login to the camera and change settings, same outcome. Any ideas on how to make...

Hi, I've been tweaking intrusion detection, line crossings and motion detection to reduce false alarms. Now every time the power goes out the cameras (or nvr) reset to motion detection on most of the cameras. Is there someplace to set a default that I'm missing? Thanks, Doug