Recent content by GYKGAMER

  1. GYKGAMER

    Does anyone have any experience with the Augentix HC1703 chip?

    Sorry again for the late reply, The issue i'm having is the fact that the pins on the SoC are absolutely tiny, I mean a grain of rice is probably bigger then the pins, it looks larger because I just zoomed in. I don't think it would be possible for me to solder that. What could I do really now?
  2. GYKGAMER

    Does anyone have any experience with the Augentix HC1703 chip?

    Here's where I found that image of the pinout by the way: Augentix - Low Power SoC Edge Security Solution -> https://www.augentix.com/_files/ugd/274150_b1992dcfb05d405d8eac4e1082f54642.pdf
  3. GYKGAMER

    Does anyone have any experience with the Augentix HC1703 chip?

    Hi there, sorry for no response for a long time, I currently have exams going on and there's still a week left of them. I haven't had time to work on the camera but I did want to do a quick check up. I did a little digging and found this diagram of the camera, there's no pinout but it shows...
  4. GYKGAMER

    Does anyone have any experience with the Augentix HC1703 chip?

    I have a raspberry pi 5, couldn't I just connect a wire to the rx to it and test each pin? I don't have oscilloscope or a logic analyser and while they are under £10, I could just manually test each one doing this.
  5. GYKGAMER

    Does anyone have any experience with the Augentix HC1703 chip?

    I had a real good look at my SoC, and unless I'm missing something, they either lead to nowhere or to the stuff that power it / what it controls, I don't see anything which could be of use (see image below of a close up), I don't really have any other ideas other than to desolder the chip and...
  6. GYKGAMER

    Does anyone have any experience with the Augentix HC1703 chip?

    My camera doesn't have any 3.3v labelling? To be fair it isn't a PTZ camera, mines like a smaller form factor one, and I have tried to use the debug_cmd.sh onto my sd card but nothing changes, I think my camera doesn't check that file, I don't think my camera even accepts serial? Unless you can...
  7. GYKGAMER

    Does anyone have any experience with the Augentix HC1703 chip?

    You say you got root access through serial, but do you need to do that to use your github repo? I'm just asking because I don't have any experience with serial at all, I only mentioned it because other ip cameras need it.
  8. GYKGAMER

    Does anyone have any experience with the Augentix HC1703 chip?

    Here's the update file by the way in case this helps in any way
  9. GYKGAMER

    Does anyone have any experience with the Augentix HC1703 chip?

    Hi there, I have this IP camera, from the brand of Shenzhen Xuanyuanxing Electronic Technology Co., Ltd. (good luck trying to say that) and i've been using one of their cameras (IT Camera X5 (2A2NI-X5)), I don't have any issues, but i've been trying to see if I don't have to use their...
See more
Top Bottom