Recent content by grfloater
-
DS-2CD2532F-IWS on V5.4.0 build 160530 loses "Enable Motion Detection"
Eureka! When you are stuck with no answers, even an indication may help (shedule, anywhere)... thanks Alastair! It was the EZVIZ... I do not remember ever setting it, it defaulted somehow: in https://ieu.ezvizlife.com/ under System Management> Device Management> Device Information, the Motion... -
DS-2CD2532F-IWS on V5.4.0 build 160530 loses "Enable Motion Detection"
yeah, thank you, drives me crazy! No sir, under "Configuration | Image | Scheduled Image Settings" I have it left in "Auto-Switch" (never touched it). I was suspecting also some "left over" shedule, searched all over, nothing. Also, the fact that at 08:00 resets also the sensitivity to 60% (from... -
DS-2CD2532F-IWS on V5.4.0 build 160530 loses "Enable Motion Detection"
Hi again, I am almost sure now: one of my 2532f domes on V5.4.0, every morning at 08:00 arbitrary stops recording events. When I check on web interface, the "Enable Motion Detection" check box is un-ticked and the sensitivity (for basic event) is reset to 60, while I set it to 20, each time... -
Hikvision camera is making continues beep
Could it be a "video loss" alarm (i.e. failure of the camera), or alarm-in pin shorted, or SD card not formatted (from newer cameras)? Dunno my friend, check also the attached manual. -
DS-2CD2532F-IWS on V5.4.0 build 160530 loses "Enable Motion Detection"
Happened several times, stops motion triggered recording, after some hours of setting it all right. Example: Yesterday set up "Basic Event" (with or without "Dynamic", does not affect it) and I was watching it on web interface, till late afternoon. Had several triggered recordings, average every...