Curious to ask if these triggers are being sent directly from the camera as a notification or is there an NVR/BI set up doing that for you?
Sent from my iPhone using Tapatalk
Tried formatting via the GUI and it's not accomplishing the task successfully. Looks like I will have to pull the camera down and manually format this on my PC.
Hi Everyone,
I recently noticed that my 5231-ZE cam was loosing connection to BI intermittently, so I looked into the logs from the camera (attached). Currently running V2.800.0000016.0.R, Build Date: 2020-06-05
Is this pointing towards a faulty SD card or buggy firmware?
Thanks!
I always thought that was depended on a managed switch so you can place them on a separate VLAN?
How do you do this on a router?
Sent from my iPhone using Tapatalk
I had a few minutes tonight to play with the settings. Left the encoding and main stream settings as before but switched a couple of items as suggested. It seems better but I have yet to test it against a moving object.
So I played around with the settings and I don't feel that I have made an improvement. Still getting blurry images when pausing on moving objects (me walking past the camera) at night. What am I doing wrong here?
Good point. I can't recall my shutter speed but will have to check it out. Is it a common practice to adjust the shutter speed between the day and night settings?
Sent from my SM-N920P using Tapatalk
Mine are currently set at 15 FPS and when pausing the footage on moving vehicles I do not get a clear picture. Does anyone else have this problem?
Sent from my SM-N920P using Tapatalk
After reading this thread entirely, it seems I should hold off upgrading to the current firmware?
I am currently running 2.622.0000000.18.R, Build Date: 2017-11-10
When looking for the "P2P" option all I could find was Network>TCP/IP> "Easy4ip" folder...is this it?
I had to upgrade to v4.8.2.5 for it to finally work (better) and get a some what constant feed from my Nest hello. I have my https link copied over from my nest "sharing" option and then set the Make = Nest/Dropcam and Model = RTMPS via public page, RTSP post = 443. It's a definite improvement...