Recent content by doctorman

for this specific doorway I need very sensitive face detection. Lorex puts the face snapshots on the side of the 8 view cam on the monitor and t is very useful in my setting. I fixed my issue with the camera by accessing its actual remote page and setting the sensitivity for face detection...

thank you so much for explaining that any advice on best setting to use for face detection in the camera? for th 10080 port issue it is explained here No Access to one CAM Web GUI behind NVR bottom line 10080 port is dangerous so all browsers have blocked it , first cam accessed gets the...

huh? found the remote page of the actual camera and found a lot of fine-tuning option with face detection , hopefully that will help, I think increasing the snap angle filter and increasing the sensitivity should help. unrelated issue, any idea why LOREX port1 camera loads as :10080 and...

Would appreciate some guidance on Lorex N842 setup to reduce the strain on the system so my face detection can work better. Is the compression and face detection done by the hardware in the camera E393 or is it done by the NVR hardware N824? If the face detection is slow or not good ...

attached is what I got from LOREX back in May 2022 LOREX_IPC-HX3XXX-Dalton_Eng_N_Stream3_V2.800.00LR000.10.R.210630.bin based on the name it seems to be from 2021 June here Dahua Technology - Leading Video Surveillance Solution Provider with CCTV Products, IP Camera, PTZ, HDCVI products...

anyway to get the release notes on this as to what was changed in each firmware update, Lorex latest version is v10 I belive now