i think default is admin/admin. yes, you can reset by holding reset button for 15s.
note if you reset, you won't be able to fully initialize, because you are required to change password on install. and for some reason you cant do this in qc view or dmss. you can then go to config tool, find...
Use QC View. DMSS works as well. You need to add the cameras directly via the IP Address. If you don't know the IP address on the cameras, you can scan via the Config Tool.
Thanks! This almost worked for me.
Adding via the cuckoo noise seemed to change the wifi settings. the indicator light turned green, suggesting it was connecting to the wifi
However, adding in the QC View app fails on the last step, where i enter the username/password. Says 'Failed to...
i have tried the config tool. i've gone through all the menus & field setting. there is no option to view/edit the wifi settings.
also, connecting to the camera via http/port 85 doesnt work either.
pls tell if i am missing something
I've tried 3 approached (all failed):
approach 1: registered the device via ethernet. then use QC view to change wifi settings. looked under "Device Mgmt", "Remove Config", "Alarm Out", "Hardware Mgmt" -- there is no option to view/change the WiFi settings. please tell me if I am missing...
OK, I installed Blue Iris (demo version).
Picked the Q-See, QC model. Though actually it's a QCW model (but model not listed).
Based on configuration settings, I don't see any options to view/edit the WiFi settings.
Am I screwed?
thanks. tried internet explorer (windows 10), edge browser, chrome, safari.
all give me the same HTTP 404 Not Found error
checked the firmware version (via config tool), its running V2.621
Thanks for the quick replies. I'll investigate.
To clarify: the camera works fine w/ DMSS, Smart PSS when physically connected w/ ethernet. But can't function w/ wireless because I am not able to view/edit the Wifi settings. Ethernet not practical for where I want to place the camera.
Tried...
I have a Q-See Wifi Camera. Model: QCW4K1MC
Without the Q-See Plus App, does anyone know how I can change the Wifi settings?
Camera does have an ethernet port, so I am able wire it to the network and add the camera to DMSS app, Smart PSS via an IP address. However, device configuration...