Recent content by brutonuk

Does anyone know how to send the html command to this camera to turn on aux1 and aux2 or even send the true pelco command through url. If i call a preset i use this command <ip>/stw-cgi/ptzcontrol.cgi?msubmenu=preset&action=control&Channel=0&Preset=86 I have seen on axis cameras you can send...

not sure why mentioning its in a ptz housing makes any difference as the control comes from the camera in the same way it controls the optical zoom

my ptz housing

current system working on

no im trying the software out to see if it is suitable for low end future projects.

I normally use seetec kayuga, Bosch BVMS and Pelco when i install on oil rigs, windfarms and submarines and dont have any problems with the Axis Q1647 which has analogue zoom. They are also installed in my PTZ housings running full PTZ without any issues

Any idea how to add an Axis Q1647? Tried allsorts of settings but get no PTZ control.

First thing i noticed is that when hovering over buttons the details pop up under the mouse icon so you cant read the info. I know i wont need that info over time but just a little observation. After setting a camera to record at 25fps it is clearly not 25 fps - is there a way to turn on stream...

Depends how many devices long term - I see you are only using a few to start with. My experience is cisco can only power around 75% of the ports and you will need 2 power supplies in the switch to use all ports. You need to look at poe or poe+. If I use an axis q6055 which is poe+ with cisco...

I dont pay for static ip and i dont know when the last time my router changed ip address. I think the last time it changed was after reporting a problem which seemed to be a dos attack on my ip but they wouldnt confirm.