I have a few cameras that are constantly giving me 8000274c - timeout check ip address and port- wyzecam (this has not changed) or http 12002 timeout errors (foscam).
I cannot hardwire these cameras.
These 2 are always the culprits.
They will eventually reconnect after some time when I power...
Sort of. I followed the instructions but when I rebooted the led just flashed yellow. I then removed the SD card. Re-booted and paired in the app and put the sd card back and it was running the beta
Sent from my SM-G955U using Tapatalk
This is what I did
Put the files on the SD card insert the SD card in run the setup when the camera reboots and starts flashing yellow remove the SD card run setup again and then insert the SD card and it should work.
Sent from my SM-G955U using Tapatalk
yeah the quality is fine too issue that I've had with wife cams and blue iris is the concert dropout because the Wi-Fi simply isn't good
Sent from my SM-G955U using Tapatalk
I'll have to check. I'm not sure. The firmware was the latest but as you.mentioned my first was the Chinese version.
Sent from my SM-G955U using Tapatalk
The stock firmware on the hikvision I had did not. The question was which firmware did I need to flash or can I flash the sane as on my Annke?
Sent from my SM-G955U using Tapatalk
Any recommendations? The Annke I had is no longer sold and this hikvision has the special characters limitations in the SSID
Sent from my SM-G955U using Tapatalk