Recent content by Anakins

  1. Anakins

    Impossible to add Ringbell DS-KV6113-WPE1(C) in NVR DS-7608NXI-I2 (HIKVISION protocol)

    It's not the good IP. Too many camera... With the good IP I have the same error than before in this menu : Device Type Mismatch
  2. Anakins

    Impossible to add Ringbell DS-KV6113-WPE1(C) in NVR DS-7608NXI-I2 (HIKVISION protocol)

    Yes I have same login/password for NVR and doorbell. Impossible, it says wring login/password :-(
  3. Anakins

    Impossible to add Ringbell DS-KV6113-WPE1(C) in NVR DS-7608NXI-I2 (HIKVISION protocol)

    Yes. Very good. Just one issue. I had it and it telle me : Incorrect User Name or Password I chekc, it's the good login password when I go on the doorbell webpage
  4. Anakins

    Impossible to add Ringbell DS-KV6113-WPE1(C) in NVR DS-7608NXI-I2 (HIKVISION protocol)

    New firmwares but not working...
  5. Anakins

    Impossible to add Ringbell DS-KV6113-WPE1(C) in NVR DS-7608NXI-I2 (HIKVISION protocol)

    Yes I understood. But it's a pitty because it works great before on my old NVR v4...
  6. Anakins

    Impossible to add Ringbell DS-KV6113-WPE1(C) in NVR DS-7608NXI-I2 (HIKVISION protocol)

    Thanks a lot for this direct link to IE. But I have always my problem with integration and the Device Type Mismatch on my new NVR v5.
  7. Anakins

    Impossible to add Ringbell DS-KV6113-WPE1(C) in NVR DS-7608NXI-I2 (HIKVISION protocol)

    Hello, I added my ringbell DS-KV6113-WPE1(C) in my old NVR DS-7608NXI-K1 (firmware v4) with no issue. I can access camera and make trigger with motion detection. I bought a DS-7608NXI-I2 (firmware v5) but impossible to add the ringbell with HIKVSION protocol. It works with HIKVISION_RSTP...
    • Anakins
    • Thread
    • device type mismatch ds-7608nxi-i2 ds-7608nxi-k1 ds-kv6113-wpe1 ds-kv6113-wpe1(c)
    • Replies: 12
    • Forum: Hikvision
  8. Anakins

    Delays issue with new NVR Hikvision.

    Just tested after reset drive and NVR with only 1 camera (2MP mode), same issue
  9. Anakins

    Delays issue with new NVR Hikvision.

    Hello, I have a NVR hikvision since 3 weeks. Model 7608 k1. I activated perimeter detection and it's working very well. The problem is : I have 3 cameras to integrate with acusense on NVR, and this model only support 2 channel ( setup to 3MP). I buy a new "i2" version to add my third camera...
See more
Top Bottom