Recent content by abyq

  1. A

    Ubiquity EdgeRouter X - Configuring to Isolate Surveillance Networks

    I've tried this and its seems still not working, from the apps side, its working if all the OP ruleset disabled. I guess I should try again with different ruleset update: its working now if I put in restricted_lan_in at first rule, thanks
  2. A

    Ubiquity EdgeRouter X - Configuring to Isolate Surveillance Networks

    I've tried this and its seems still not working, from the apps side, its working if all the OP ruleset disabled. I guess I should try again with different ruleset
  3. A

    Ubiquity EdgeRouter X - Configuring to Isolate Surveillance Networks

    I'm trying to get a push notifications (GDMSS Plus), I've created a ruleset in WAN_OUT source camera_ip destination port 2195, but it seems not working, any idea where should I put the outbound for port 2195 ? thank you
  4. A

    Ubiquity EdgeRouter X - Configuring to Isolate Surveillance Networks

    it is fine if I uncheck the eth2 port from hairpin and mdns ?
  5. A

    Ubiquity EdgeRouter X - Configuring to Isolate Surveillance Networks

    Thanks for the explanation, I guess I will choose NVR with separated POE switch, since I already setup a wireguard in the router so I can easily access both NVR and camera another question: 1. in OP configuration, there is Hairpin NAT >> eth1 and eth2, what is the explanation for only this...
  6. A

    Ubiquity EdgeRouter X - Configuring to Isolate Surveillance Networks

    if I want using a NVR, the camera should be connected from NVR LAN, does it means I should buy a NVR built-in switch ? why I cannot plug directly together with camera in the same switch ?
See more
Top Bottom