Recent content by About TO Retire

The trouble I has all the cameras have been updated firmware and I can't go back. I didn't dig deep enough before I upgraded

The NVR is a DHI-NVR5864-I/L WizMind and the Cameras are IP5M-T1179EW there are only 25 cameras on this system because when we had 54 on it would freeze up. most of the frame rates are at 7 and the bite rate are 1732, the cameras are at 1080P.

I understand but I don't believe they have been hacked there are no signs of it at least but you never know they are always finding ways to get in. But no port forwarding is been done. This system is supposed to be a deep learning algorithm system and we are not using any of it because what ever...

I would not think I needed to because this is happening on the NVR it's self. This is a 64 camera system and it's only got 25 working on it and it still slows down where the client can't view the recording. so they have to reboot it then it's fine for a while?

Yeah it's sad to say but they don't up the prossers un less you request it and they don't tell you about it either

Yes I'll see if I can get the specs Attached for both systems. Spec Sheet - Google Drive

I'm not either I learned the old way watch, listen, ask lots of questions and do. lol

We use these cameras on the 16 channel and smaller systems and they work no problem. The encode is H265 but we did try H264 and it did the same thing. Even set the cameras to ONVIF that still didn't help. Im just hopping someone that has been through this can send some light my way. LOL

But were not doing any of the good things this system is supposed to be able to do. I think we have 9 cameras set to 5MP at 10fps. Bit stream is at 1792 StreamCtrl VBR on all cameras

Now we did have another32 camera system I replaced and had 5 Amcrest cameras on it. It would lock up stop working I would reboot it and it would be fine for half the day then it would be back to freezing up. I replaced those Amcrest cameras and all is right with it. Knock on wood.

Just did and no skip or jump after the download to my desktop using smartPSS

SmartPSS Would not let me and neither would the webUI I had to go on site to be able to turn it back on. and today I had another system do the something but it was only 4 cameras.

But this would not cause the system to just turn off the motion detection on different cameras would it?

These are the specs for the 64 channel system