dahua

Hello everyone, I want to first thank everyone that shares so much knowledge on this forum. I am a rookie when it comes to the IP Cam world and spending time on this website has helped immensely. I just purchased cameras from Empire Andy and finished the installation on my home. Learning how to...

Hi, I'm a new user of dahua 8 channel system (DH-XVR1B08H-I) with 6 cameras. When I connected to the system through WiFi and trough my PC, I cannot search for snapshots (I can search only for recordings). Drop-down list contains only "Record" option. But from DVR (if I connect a mouse to the...

I have Dahua Imou ranger 2 and it was not updating to the latest firmware so i decided to reset it. but as soon as i reset it, it's not initializing. it just keeps showing blinking red light but does not initialize. I tried changing my IP to 192.168.1.2(as cam's ip is 192.168.1.108) but on Dahua...

I don't have NVR or DVR so I create many gmail accounts so my camera can send me notifications but the emails are working for a couple of days and then it says fail when I test the email in the network tab smtp. I can't buy DVR right now but I still want to receive notifications. Can I buy my...

I have a 2-wire setup (ip-gateway) with 1x VTO (modular) at front door and 3x VTH for each floor. The default factory image was v3.12x (non-SIP) and has been upgraded to v4.3 SIP. The upgrade from 1 of 3 VTH devices failed but could be recovered using TFTP method. Upgrade Steps: - upgraded...

Hello all, First time poster, long time reader. I have the above model number Dahua NVR system. It works perfectly fine, except recently when trying to install a HDD. As soon as i try to connect the SATA 15 pin to 4 pin plug into the motherboard the display to the TV is lost. Once removed...

Hello, I'm trying these strings on VLC without success rtsp:/stream:Stream1!@192.168.7.45:554/cam/realmonitor?channel=1&subtype=0 rtsp:/stream:Stream1!@192.168.7.45:554/cam/realmonitor?channel=1&subtype=1 rtsp:/stream:Stream1!@192.168.7.45:554/cam/realmonitor?channel=1&subtype=2 could you...

Hi guys, i have setup IVS on my NVR and purposefully unchecked certain time slots in the Schedule setting to NOT receive any alerts during this time. However the DMSS alerting on the iPhone disregards this unchecks and keeps sending me multiple alert during the blacked out times. how do I...

Hello, I own Dahua SD59225. I want to access my camera from my other network because where the camera is located I don't stay there all day so I need to access the camera IP in the browser from my other network where I spend most of my time. Currently I'm using an app gDMSS which is great but...

Hi Folks, A new poster alert! I am working on my humble setup - IP Cameras (4), WAPs (3) & Intercom (1 door station & 2 monitors) and I would need your assistance on the same. Will I be able to achieve the below setup? If yes, what kind of NVR should I go with? Or should I go with two NVRs...

Hello, My camera model is Dahua SD59225U-HNI. For the last couple of days I experience problem with the camera. It's lagging when I watch live from the app gDMSS but it's lagging only when I watch with different network than what the camera uses. It goes from 150 kb\s to 60 kb/s then 20 kb/s...

Hello good afternoon, I have a Dahua HCVR7108H system with 4 cameras connected. The system has always worked fine, however recently in the middle of the night it started to beep. To stop the noise I turned it off and on again, and from there, it didn't work anymore! The front and inside(board)...

I have added 2 Hikvision DS-2CD2442FWD-IW cameras on a Dahua XVR but there is no audio as wells as 2-way audio. I tried to add the cameras also on Synology's Surveilance Station and there' still no sound but 2-way audio is operational. Is there any recommendation/setting to try? Thanks in advance!!

Hello Does anyone know if it is possible to improve the appearance of the image of the cameras switched to corridor mode? I have cameras filming store and warehouse shelves, I rotated the cameras 90° and set the "flip" setting to 90° too. The image is therefore straight on the mosaic but...

Hello guys, I bought the SD49225XA-HNR from Andy last year and only just had a chance to mount it. Yesterday before I mounted it I gave it a quick test, connected the cam to my old Netgear GS110TP POE switch logged into the cam directly on .108 and although the camera was working when I tried...

Title. I know the Dahua PFA130-E mount comes with one of these black rubber plugs where the camera mounts flush to the base of this mount. I am wondering if anyone knows where I can buy more of them or somehow get 3D prints of it?

Hello guys, I was currently checking to buy a new doorbell and saw these 2: https://www.hikvision.com/en/products/Video-Intercom-Products/IP-Series/Pro-Series/DS-KD8003-IME1-Flush/...

Hi All, Any help appreciated. I understand it may be simple, but I'm a newbie. I have a Unifi USG, 2 AP's and 3 switches. I have a Dahua NVR on its own VLAN. I have a rule to block all traffic (Lan_IN) from the VLan the NVR is sitting on, to stop it connecting to the internet, for...

Background: For many years I’ve used Dahua DVRs plus SmartPSS on the Mac. I like the technical capabilities and functionality of SmartPSS, despite some obvious flaws, and hate most of the crappy phone apps available to access these units. Outside motion detection is problematic but I use...

Hi, My Dahua NVR has started throwing bad sector errors on internal disk. I have a spare WD Red 4TB disk sitting, which has been in light NAS use, but has no SMART errors. Can there be any issues with putting this disk in the NVR ? Cheers