Recent content by Cleve

I figured it out, apparently i hit and held down the "-" button for a long time and did not know it. I held down the "+" button for awhile and it started playing forward..

I have four blue iris systems that I monitor on my iPhone 14. When I check and review the video's, they play backwards. The blue iris web as well as my ipad all operate correctly. Is there some kind of setting on the phone that would correct this?

Ok, I will give all the suggestions a shot. Thanks

I walked around in front of the cameras and they all recorded me but only two activated the PTZ. One of the cameras that the PTZ responds to is a new camera. Im thinking that I have a setting in the others set different for the Home profile. For instance when I walked in front of the cameras...

I have several outside cameras that are stationary. I have one that is a PTZ camera. I have each camera programmed to send a command to the PTZ camera when they are triggered. When a trigger occurs, the PTZ will change presets and look in the general area of the activated camera. I can run a...

That was it! I disabled ONVIF in the camera Web setting and everything is working just fine. Thanks!

Ok Thanks, I will give that a shot.

Hello, I have a Amcrest PTZ camera that I can't get the settings pulled down to Blue Iris. Sub stream is enabled in the camera settings but I can not change resolution to anything higher than 2560X1440. The preset are set in the camera setting and they work fine. The video of the camera is...

OK Thanks, I Think I got it figured out/

I have a PTP bridge set up between my house and pump house. In the pump house is a ubiquiti managed switch. It has two POE cameras and a AP connected to it. I tagged ports 2 and 3 with VLAN 40 which is my camera network. Dash board shows those ports tagged in the Camera network but the...

I have been having some issues with a Amcrest PTZ camera in the BI 5 Version. Camera is not pulling down settings from the Camera Gui such as the presets, the main stream, and sub stream. I have uninstalled and re-installed the camera several times. I have been able to get the presets working...

Update, apparently this PTZ camera of mine was just on vacation! It started back working on its on today but under the video/Config tab the main stream and sub stream do not look correct and I am afraid to hit find and inspect. I did uninstall and reinstall the camera again this morning but it...

OK, Thanks

I logged into the web GUI and found the ONVIF tab but the only options are under network connection. Only options are, "Reset Defaults", "Refresh", "Save". I tried both but no luck. Also, I do have another PTZ camera and I went through the Config process with it and it pulled down the presets...

Hello Tony and thanks for the reply. That's what I have been doing, hitting Find/Inspect. I have checked the password and the IP address and both appear to be correct. I got the IP address through Amcrest IP config app. Below is what is coming back when I hit Find/Inspect. Requesting...